R&S FSL SENSe Subsystem (WCDMA, K72)
1300.2519.12 6.589 E-11
Characteristics
RST value: NOR
SCPI: device–specific
Mode
WCDMA
[SENSe<1|2>:]CDPower:SLOT
This command selects the slot that is evaluated in the Code Domain Power Diagram and is
used for slot–based evaluations in the Code Domain Result Summary.
The numeric suffixes <1|2> are irrelevant for this command.
Parameter
0 to 14
Example
CDP:SLOT 3
Selects slot 3.
Characteristics
RST value: 0
SCPI: device–specific
Mode
WCDMA
[SENSe<1|2>:]CDPower:STYPe
This command defines the synchronization..
The numeric suffixes <1|2> are irrelevant for this command.
Parameter
CPICh A synchronization to the CPICH control channel is performed. As a prerequisite,
the CPICH control channel must be present in the signal.
SCHannel A synchronization without assuming the presence of a CPICH channel is
performed.
While this setting can also be used with other channel configurations, but the
probability of synchronization failure increases with the number of data channels.
Example
CDP:STYP SCH
A synchronization without assuming the presence of a CPICH channel is performed.
Characteristics
RST value: CPICH
SCPI: device–specific
Mode
WCDMA
To Next Page
Loading...
