Rohde & Schwarz R&S FSL3 - Page 1417

Remote Commands of the 1xEV-DO BTS Analyzer Option (K84) R&S FSL
1300.2519.12 6.658 E-11
[SENSe<1|2>:]CDPower:IQLength
This command sets the capture length in multiples of the power control group.
The numeric suffix at SENSe<1|2> is irrelevant for this command.
Parameter
2 to 12
E
xample
CDP:IQL 8
Sets 8 PCGs as capture length.
Characteristics
RST value: 3
SCPI: device-specific
Mode
EVDO
[SENSe<1|2>:]CDPower:CTYPe
This command is used to select the channel type. The number of results then changes in most
analyses, such as code domain power, symbol EVM, and bit stream, because either a different
spreading factor or a different number of symbols is available for the analysis.
Parameter
PILot | MAC | PREamble | DATA
Example
CDP:CTYP MAC
Select MAC channel type.
Characteristics
RST value: PILOT
SCPI: device-specific
Mode
EVDO
[SENSe<1|2>:]CDPower:ICTReshold
This command defines the minimum power which a single channel must have compared to the
total signal in order to be regarded as an active channel. Channels below the specified
threshold are regarded as "inactive".
The numeric suffix at SENSe<1|2> is irrelevant for this command.
Parameter
–100 dB to 10 dB
Example
CDP:ICTR –10
Sets the minimum power threshold to –10 dB.