R&S FSL SENSe Subsystem (WLAN, K91 / K91n)
1300.2519.12 6.735 E-11
[
SENSe:]DEMod:FORMat:BANalyze:SYMBols:MIN
This command specifies the number of data symbols required for bursts to qualify for
measurement analysis. Only bursts with the specified number of symbols will be used in the
measurement analysis. The number of data symbols is defined as the uncoded bits including
service and tail bits.
When the [SENSe:]DEMod:FORMat:BANalyze:SYMBols:EQUal command has been set to
true then this command specifies the exact number of symbols required for a burst to take part
in measurement analysis. When the [SENSe:]DEMod:FORMat:BANalyze:SYMBols:EQUal
command is set to false this command specifies the minimum number of symbols required for a
burst to take part in measurement analysis.
Parameter
<numeric_value>
Example
DEM:FORM:BAN:SYM:MIN 16
Only bursts which contain a symbol count of 16 are analyzed.
Characteristics
*RST value: 1
SCPI: device–specific
Mode
WLAN
[SENSe:]DEMod:FORMat:BTRate
The remote control command is used to specify the bit rate for IEEE 802.11b signals. This
command can be used as an alternative to [SENSe:]DEMod:FORMat:BANalyze. The bit rate
can be set as follows:
Parameter
10 1 Mbit/s
20 2 Mbit/s
55 5.5 Mbit/s
110 11 Mbit/s
Example
DEM:FORM:BTR 20
Configures to demodulate 2 Mbit/s signals
Characteristics
*RST value: 10 (= 1mbit)
SCPI: device–specific
Mode
WLAN
To Next Page
Loading...
