CALCulate:LIMit Subsystem (WiMAX, K92/K93) R&S FSL
1300.2519.12 6.768 E-11
C
haracteristics
RST value: –
SCPI: device–specific
M
ode
OFDM, OFDMA/WiBro
CALCulate<1|2>:LIMit<1...8>:BURSt:FERRor:MAXimum:RESult?
This command returns the maximum frequency error limit result.
The numeric suffixes <1|2> sets the measurement window for the calculation and the suffixes
<1...8> specify the limit lines (see CALCulate<1|2>:LIMit<1...8>:FAIL? command).
This command is only a query and therefore has no *RST value.
Return values
0 PASSED
1 FAILED
Example
CALC:LIM:BURS:FERR:MAX:RES?
Maximum frequency error limit result is returned
Characteristics
RST value: –
SCPI: device–specific
Mode
OFDM, OFDMA/WiBro
CALCulate<1|2>:LIMit<1...8>:BURSt:IQOFfset[:AVERage]
This command sets the average IQ offset error limit.
The numeric suffixes <1|2> sets the measurement window for the calculation and the suffixes
<1...8> specify the limit lines (see CALCulate<1|2>:LIMit<1...8>:FAIL? command).
Parameter
–1000000 to 1000000 dB or %
If no unit is specified the unit specified by the UNIT:TABLe command is used.
Example
CALC:LIM:BURS:IQOF –10.0
Average IQ offset error limit is set to –10.0 dB.
Characteristics
*RST value: –
SCPI: device–specific
Mode
OFDM, OFDMA/WiBro
To Next Page
Loading...
