CALCulate:MARKer Subsystem (WiMAX, K92/K93) R&S FSL
1300.2519.12 6.778 E-11
E
xample
C
ALC2:MARK:SYMB 2
Positions marker 1 in screen B to symbol 2.
CALC2:MARK:SYMB?
Outputs the symbol value of marker 1 in screen B.
Characteristics
RST value: –
SCPI: device–specific
Mode
OFDM, OFDMA/WiBro
CALCulate<1|2>:MARKer<1>:TRACe
This command assigns the selected marker to the indicated measurement curve in the selected
measurement window.
This command is only available for the following result displays:
– Constellation vs Carrier
– EVM vs Symbol
– EVM vs Carrier
– Frequency Error vs Preamble
– Phase Error vs Preamble
– PVT Rising / Falling
– Spectrum Flatness
– Spectrum Flatness Difference
– Spectrum Mask – if Max Hold trace mode is activated
– Spectrum ACP/ACPR – if Max Hold trace mode is activated
Parameter
1 to 3
Example
CALC2:MARK:TRAC 2
Assigns marker 1 in screen B to trace 2.
Characteristics
RST value: 1
SCPI: device–specific
Mode
OFDM, OFDMA/WiBro
To Next Page
Loading...
