Rohde & Schwarz R&S FSL3 - Page 1549

CONFigure Subsystem (WiMAX, K92/K93) R&S FSL
1300.2519.12 6.790 E-11
CONFigure:BURSt:PREamble[:IMMediate]
This command configures the Phase or Frequency vs Preamble measurement type. The
selection between the both measurements is made via the
CONFigure:BURSt:PREamble:SELect command.
This command is an event and therefore has no *RST value and no query.
Example
CONF:BURS:PRE
Configures the Phase or Frequency vs Preamble measurement type.
CONF:BURS:PRE:SEL FREQ
The measurement results are interpreted as Frequency Error vs Preamble.
INIT
Starts a Frequency Error vs Preamble measurement.
Characteristics
RST value: –
SCPI: device–specific
Mode
OFDM, OFDMA/WiBro
CONFigure:BURSt:PREamble:SELect
This command configures the interpretation of the preamble measurement results.
Parameter
PHASe | FREQuency
Example
CONF:BURS:PRE
Configures the Phase or Frequency vs Preamble measurement type.
CONF:BURS:PRE:SEL FREQ
The measurement results are interpreted as Frequency Error vs Preamble.
Characteristics
RST value: –
SCPI: device–specific
Mode
OFDM, OFDMA/WiBro
CONFigure:BURSt:PVT[:IMMediate]
This command configures the Power vs Time (PVT) measurement type. For further settings of
the Power vs Time measurement see the CONFigure:BURSt:PVT:BURSt and
CONFigure:BURSt:PVT:SELect commands.
This command is an event and therefore has no *RST value and no query.
Example
CONF:BURS:PVT
Configures the Power vs Time measurement type.
INIT
Starts a Power vs Time measurement.