R&S FSL CONFigure Subsystem (WiMAX, K92/K93)
1300.2519.12 6.791 E-11
Characteristics
RST value: –
SCPI: device–specific
Mode
OFDM, OFDMA/WiBro
CONFigure:BURSt:PVT:BURSt
This command specifies the burst that is used for the Power vs Time measurement results.
Parameter
1 to 10922
Example
CONF:BURS:PVT
Configures the Power vs Time measurement type.
CONF:BURS:PVT:BURS 1
Uses burst 1 for the Power vs Time measurement results.
Characteristics
RST value: –
SCPI: device–specific
Mode
OFDM
CONFigure:BURSt:PVT:SELect
This command configures the interpretation of the Power vs Time (PVT) measurement results.
The available measurement types depend on the selected standard.
Parameter
FULL PVT Start and End OFDM
PVT Rsing / Falling OFDMA/WiBro
EDGE PVT Full Burst OFDM
PVT Full Subframe OFDMA/WiBro
Example
CONF:BURS:PVT
Configures the Power vs Time measurement type.
CONF:BURS:PVT:SEL FULL
The measurement results are interpreted as full burst.
Characteristics
RST value: FULL
SCPI: device–specific
Mode
OFDM, OFDMA/WiBro
To Next Page
Loading...
