Rohde & Schwarz R&S FSL3 - Page 1571

DISPlay Subsystem (WiMAX, K92/K93) R&S FSL
1300.2519.12 6.812 E-11
DISPlay[:WINDow<1|2>]:SSELect
This command selects whether screen A or screen B is active. The numeric suffix <1|2> defines
the active window.
Example
DISP:WIND1:SSEL
Sets screen A active.
Characteristics
RST value: –
SCPI: device–specific
Mode
OFDM, OFDMA/WiBro
DISPlay[:WINDow<1|2>]:TABLe
This command shows or hides the results table.
The numeric suffix <1|2> defines the active window.
Parameter
ON | OFF
Example
DISP:TABL OFF
Hides the results table.
Characteristics
RST value: OFF
SCPI: device–specific
Mode
OFDM, OFDMA/WiBro
DISPlay[:WINDow<1|2>]:TABLe:UNIT
This command specifies the unit for the parameters listed in the results table.
The numeric suffix <1|2> defines the active window.
Parameter
DB results returned in dB
PCT results returned in percent
Example
DISP:TABL:UNIT DB
Results are returned in dB.
Characteristics
RST value: DB
SCPI: device–specific
Mode
OFDM, OFDMA/WiBro