FETCh Subsystem (WiMAX, K92/K93) R&S FSL
1300.2519.12 6.820 E-11
FETCh:BURSt:COUNt?
This command returns the number of bursts analyzed in the last sweep.
This command is only a query and therefore has no *RST value.
Example
FETC:BURS:COUN?
The number of analyzed bursts in the most recent measurement is returned.
Characteristics
RST value: –
SCPI: device–specific
Mode
OFDM, OFDMA/WiBro
FETCh:BURSt:CRESt:AVERage? / FETCh:BURSt:CRESt:MAXimum? /
FETCh:BURSt:CRESt:MINimum?
This command returns the determined crest factor (average, minimum or maximum value) in
dBm. The crest factor is the ratio of peak power to average power.
This command is only a query and therefore has no *RST value.
Example
FETC:BURS:CRES:MAX?
The calculated maximum crest factor from the most recent measurement is returned.
Characteristics
RST value: –
SCPI: device–specific
Mode
OFDM, OFDMA/WiBro
FETCh:BURSt:EVM:ALL:AVERage? / FETCh:BURSt:EVM:ALL:MAXimum? /
FETCh:BURSt:EVM:ALL:MINimum?
This command returns the Error Vector Magnitude (EVM) measurement results summary
(average, minimum or maximum value) in dB. The results summary is a combined figure that
represents the pilot, data and the free carrier.
This command is only a query and therefore has no *RST value.
Example
FETC:BURS:EVM:ALL:MIN?
The minimum Error Vector Magnitude value is returned.
Characteristics
RST value: –
SCPI: device–specific
Mode
OFDM, OFDMA/WiBro
To Next Page
Loading...
