Rohde & Schwarz R&S FSL3 - Initiate Subsystem (Wimax, K92;K93)

R&S FSL INITiate Subsystem (WiMAX, K92/K93)
1300.2519.12 6.829 E-11
INITiate Subsystem (WiMAX, K92/K93)
The INITiate subsystem configures the instrument prior to a measurement being carried out. It is
basically used to tell the instrument which measurement is to be performed and takes any necessary
step to set up the instrument for the measurement.
Commands of the INITiate Subsystem
– INITiate[:IMMediate]
– INITiate:CONTinuous
– INITiate:REFResh
INITiate[:IMMediate]
For further details refer to "INITiate<1|2>[:IMMediate]" on page 6.146.
INITiate:CONTinuous
For further details refer to "INITiate<1|2>:CONTinuous" on page 6.147.
INITiate:REFResh
This command updates the current IQ measurement results to reflect the current measurement
settings. Note that no new IQ data is captured, i.e. the measurement settings apply to the IQ
data being currently in the capture buffer. The command applies exclusively to IQ
measurements. It requires available IQ data.
Example
INIT:REFR
Updates the IQ measurement results according to the current settings.
Characteristics
RST value: –
SCPI: conform
Mode
OFDM, OFDMA/WiBro