R&S FSL SENSe Subsystem (WiMAX, K92/K93)
1300.2519.12 6.841 E-11
[
SENSe:]POWer:ACHannel:BANDwidth|BWIDth[:CHANnel]
This command sets the channel bandwidth of the system. The bandwidths of adjacent channels
are not influenced by this modification.
Parameter
0 Hz to 100 GHz
Example
POW:ACH:BAND 30kHz
Sets the bandwidth of the TX channel to 30 kHz.
Characteristics
RST value: –
SCPI: device–specific
Mode
OFDM, OFDMA/WiBro
[SENSe:]POWer:ACHannel:BANDwidth|BWIDth:ACHannel
This command defines the channel bandwidth of the adjacent channel of the system.
Parameter
0 Hz to 100 GHz
Example
POW:ACH:BAND:ACH 30kHz
Sets the bandwidth of the adjacent channel to 30 kHz.
Characteristics
RST value: –
SCPI: device–specific
Mode
OFDM, OFDMA/WiBro
[SENSe:]POWer:ACHannel:BANDwidth|BWIDth:ALTernate<1|4>
This command defines the channel bandwidth of the first to fourth alternate adjacent channel of
the system.
Parameter
0 Hz to 100 GHz
Example
POW:ACH:BAND:ALT2 30kHz
Sets the bandwidth of the second alternate adjacent channel to 30 kHz.
Characteristics
RST value: –
SCPI: device–specific
Mode
OFDM, OFDMA/WiBro
To Next Page
Loading...
