R&S FSL Power Measurements – MEAS Key
1300.2519.12 4.93 E-11
Std Dev (zero span)
Activates the calculation of the standard deviation of measurement points from the mean value
and displays them as measured value. The measurement of the mean power is automatically
switched on at the same time. For more details see also "Power measurement in zero span" on
page 4.78.
Remote: CALC:MARK:FUNC:SUMM:SDEV ON
Remote: CALC:MARK:FUNC:SUMM:SDEV:RES?
Limits On/Off (zero span)
Switches the limitation of the evaluation range on or off. Default setting is off.
If switched off, the evaluation range is not limited. If switched on, the evaluation range is defined
by the left and right limit. If only one limit is set, it corresponds to the left limit and the right limit is
defined by the stop frequency. If the second limit is also set, it defines the right limit.
For more details see also "Power measurement in zero span" on page 4.78.
Remote: CALC:MARK:X:SLIM OFF
Left Limit (zero span)
Opens an edit dialog box to enter a value for line 1. For more details see also "Power
measurement in zero span" on page 4.78.
Remote: CALC:MARK:X:SLIM:LEFT <value>
Right Limit (zero span)
Opens an edit dialog box to enter a value for line 2. For more details see also "Power
measurement in zero span" on page 4.78.
Remote: CALC:MARK:X:SLIM:RIGH <value>
C/N, C/No (span > 0)
Opens a submenu to configure the carrier/noise ratio measurement. Measurements without
(C/N) and measurements with reference to the bandwidth (C/No) are possible.
C/N (span > 0)
Switches the measurement of the carrier/noise ratio on or off. If no marker is active, marker 1 is
activated.
The measurement is performed on the trace where marker 1 is located. To shift marker 1 and
measure another trace, use the Marker to Trace softkey in the marker menu. To determine the
maximum value of the current trace, use the Phase Noise/Ref Fixed softkey in the marker
menu.
Remote: CALC:MARK:FUNC:POW:SEL CN
Remote: CALC:MARK:FUNC:POW:RES? CN
Remote: CALC:MARK:FUNC:POW OFF
To Next Page
Loading...
