R&S FSL Power Measurements – MEAS Key
1300.2519.12 4.107 E-11
Sweep Time (Sweep List dialog box)
Sets the sweep time value for the range.
Remote: ESP:RANG1:SWE:TIME 1 (Spectrum Emission Mask)
Remote: LIST:RANG1:SWE:TIME 1 (Spurious Emissions)
Detector (Sweep List dialog box, Spurious Emissions)
Sets the detector for the range. For details refer to "Detector overview" on page 4.42.
Remote: LIST:RANGe3:DET SAMP
Ref. Level (Sweep List dialog box)
Sets the reference level for the range.
Remote: ESP:RANG2:RLEV 0 (Spectrum Emission Mask)
Remote: LIST:RANG2:RLEV 0 (Spurious Emissions)
RF Att. Mode (Sweep List dialog box)
Activates or deactivates the auto mode for RF attenuation.
Remote: ESP:RANG2:INP:ATT:AUTO OFF (Spectrum Emission Mask)
Remote: LIST:RANG2:INP:ATT:AUTO OFF (Spurious Emissions)
RF Attenuator (Sweep List dialog box)
Sets the attenuation value for that range.
Remote: ESP:RANG3:INP:ATT 10 (Spectrum Emission Mask)
Remote: LIST:RANG3:INP:ATT 10 (Spurious Emissions)
Preamp (Sweep List dialog box)
Switches the preamplifier on or off.
Remote: ESP:RANG3:INP:GAIN:STATe ON (Spectrum Emission Mask)
Remote: LIST:RANG3:INP:GAIN:STATe ON (Spurious Emissions)
Sweep Points (Sweep List dialog box, Spurious Emissions)
Sets the number of sweep points per range. For details on possible values refer to the Sweep
Points softkey of the sweep menu.
Remote: LIST:RANG3:POIN 601
To Next Page
Loading...
