Analog Demodulation (Option K7) R&S FSL
1300.2519.12 4.152 E-11
Softkeys of the span menu (Analog Demodulation mode)
The following table shows all softkeys available in the span menu in Analog Demodulation mode
(SPAN key). It is possible that your instrument configuration does not provide all softkeys. If a softkey is
only available with a special option, model or (measurement) mode, this information is delivered in the
corresponding softkey description.
Command
Span Manual/AF Span Manual
Demod Bandwidth
Full Span/AF Full Span
Span Manual (RF Spectrum)
If the RF spectrum display is active, values between the sampling rate/200 and the
demodulation bandwidth/2 are allowed.
For further details refer to the Span Manual softkey in the span menu of the base unit.
Remote: ADEM:SPEC:SPAN:ZOOM 5 MHz
AF Span Manual (AF Spectrum)
Opens an edit dialog box to enter the frequency range for the AF spectrum display. Values
between the sampling rate/1000 and the demodulation bandwidth/2 are allowed.
Remote: ADEM:AF:SPAN 2.5 MHz
Demod Bandwidth
For details see Demod BW softkey in the analog demodulation menu.
Full Span (RF Spectrum)
If the RF spectrum display is active, the full frequency range corresponds to the demodulation
bandwidth.
For further details refer to the Full Span softkey in the span menu of the base unit.
Remote: ADEM:SPEC:SPAN:ZOOM MAX
AF Full Span (AF Spectrum)
Sets the span to the maximum frequency range for the AF spectrum display. The maximum
frequency range corresponds to the demodulation bandwidth.
Remote: ADEM:AF:SPAN:FULL
To Next Page
Loading...
