Bluetooth Measurements (Option K8) R&S FSL
1300.2519.12 4.178 E-11
Continue Test (Modulation Char)
Measures the frequency deviation of further packets after the bit pattern has been changed at
the EUT, just like the Start Test softkey did for the first bit pattern type. The results of the
preceding measurement are preserved and are taken into account for the new measurements.
Remote: INIT:CONM;*WAI
Continuous Sweep
Selects the continuous measurement operation. This is the default setting of the instrument.
Remote: INIT:CONT ON;*WAI
Single Sweep
(Output Power, TX Spec ACP, Init Carr Freq Tol, Carr Freq Drift, Rel TX Power, Spurious
Emissions, Carr Freq Stability, Diff Phase)
Selects the single measurement operation and starts a measurement cycle.
Remote: INIT:CONT OFF;*WAI
Block Count (Carr Freq Stability)
Opens an edit dialog box to enter the number of blocks to be measured. Every block has the
length of 50 Ms. The default value is 200 blocks.
This softkey is only available in single sweep operation.
Remote: CONF:BTO:CFST:BCO 1000
Adjust Gate (Spurious Emissions)
Adjusts the gate settings according to the pre–measurement results.
Remote: CONF:BTO:IBS:GATE:AUTO ONCE
Sweep Count
(Output Power, TX Spec ACP, Modulation Char, Init Carr Freq Tol, Carr Freq Drift, Rel TX Power,
Spurious Emissions, Diff Phase)
Opens an edit dialog box to enter the number of sweeps to be initiated by Single Sweep
softkey. The valid value range is 0 to 32767.
Remote: CONF:BTO:SWE:COUN 20
Power Avg Start (Output Power)
Opens an edit dialog box to enter the start position of the evaluation area for the average burst
power. The values range from 0 to 100%, the default setting is 20%.
For further information refer to "Position of a Bluetooth burst" on page 4.160.
Remote: CONF:BTO:POW:AVER:STAR 10PCT
To Next Page
Loading...
