R&S FSL Cable TV Measurements (Option K20)
1300.2519.12 4.223 E-11
7. Press the RUN key.
For a more detailed description of this measurement type refer to chapter "Advanced Measurement
Examples".
Softkeys of the Cable TV Analyzer menu
The following table shows all softkeys available in the Cable TV Analyzer menu. It is possible that your
instrument configuration does not provide all softkeys. If a softkey is only available with a special option,
model or (measurement) mode, this information is delivered in the corresponding softkey description.
Menu / Command Submenu / Command Submenu / Command Command
Channel Setup Activate
New Copy Channel
Delete Channel
Modulation Options New
Delete
Edit
Save Changes
Discard Changes
Copy same contents as New
menu
Delete
Edit same contents as New
menu
Restore Default Tables
Adjust Attenuation
Channel Setup
Opens the Channel Tables dialog box with all available channel tables listed, and displays a
submenu to activate, create, edit, copy, and delete channel tables and modulation standards.
For further information on channel tables refer to "Channel tables" on page 4.210 and
"Modulation standards" on page 4.210.
Activate
Activates the channel table in focus. Alternatively to this softkey, the rotary knob or the ENTER
key can be pressed.
Activating a channel table is synonymous to loading the selected channel table and discarding
the previously active channel table. As a prerequisite, the channel table must have at least one
channel with a digital or analog modulation standard. Otherwise the channel table cannot be
loaded and an error message is displayed. If no appropriate channel table exists, select
< none > for no channel table.
Remote: CONF:TV:CTAB:SEL 'TV–ITALY'
To Next Page
Loading...
