WLAN TX Measurements (Option K91 / K91n) R&S FSL
1300.2519.12 4.416 E-11
Auto Lvl
Ext Att
Data Capture Settings Capture Time
Burst Count
Analyze Bursts
Sweep Count
Trigger Settings Trigger Mode
Trigger Offset
Power Level
Auto Lvl
IQ Settings Swap IQ
Advanced Settings Auto Level Time
Ref Level
Attenuation
Sample Rate
In the Demod Settings dialog box, the settings associated with the signal modulation can be
modified. The settings under Burst to Analyze specify the characteristics of the bursts to be
considered in the measurement results. Only the bursts which meet the criteria specified in this
group will be included in measurement analysis if the Use Header Content option is activated.
The tracking settings allow various errors in measurement results to be compensated for.
The Demod Settings dialog box contains the following elements. If an element is only available
for certain standards, the corresponding standards are listed.
Burst to Analyze Signal Field Content
Use Header Content
Burst Type
Preamble Type
Auto Demodulation
Analyze PSDU Mod
Demodulator
Auto Guard
Guard Interval
PPDU Frame Format
Equal Burst Length
Data Symbols
Min Data Symbols
Max Data Symbols
Channel Estimation
Payload Length
Min Payload Length
Max Payload Length
Tracking Phase
Timing
Level
To Next Page
Loading...
