R&S FSL WLAN TX Measurements (Option K91 / K91n)
1300.2519.12 4.419 E-11
Power Level (General Settings dialog box)
Specifies the trigger level if the Power trigger mode is set.
Remote: TRIG:LEV:POW 10 DBM
A
uto Lvl (General Settings dialog box)
Activates or deactivates the automatic measurement of the power trigger level.
On The power trigger level is measured automatically at the start of each measurement
sweep. This ensures that the power trigger level is always set at the optimal level for
obtaining accurate results but will result in a slightly increased measurement times.
Off
The power trigger level is defined manually in the Power Level field.
Remote: TRIG:LEV:POW:AUTO ON
Swap IQ (General Settings dialog box)
Activates or deactivates the inverted I/Q modulation.
On I and Q signals are interchanged.
Off Normal I/Q modulation.
Remote: SWAP ON
Auto Level Time (General Settings dialog box)
Specifies the sweep time used for the automatic level measurements.
Remote: CONF:POW:AUTO:SWE:TIME 200MS
Ref Level (General Settings dialog box)
Specifies the reference level to use for measurements. If the reference level is modified, the
signal level is updated accordingly (depending on the currently selected standard and
measurement type). This field is only editable if the Auto Lvl is deactivated.
Remote: DISP:TRAC:Y:RLEV?
Attenuation (General Settings dialog box)
Specifies the settings for the attenuator. This field is only editable if the Auto Lvl option is
deactivated. If the Auto Lvl option is activated, the RF attenuator setting is coupled to the
reference level setting.
Remote: INP:ATT 30dB
Sample Rate (General Settings dialog box)
Specifies the sample rate used for IQ measurements.
Remote: TRACE:IQ:SRAT 20000
To Next Page
Loading...
