WLAN TX Measurements (Option K91 / K91n) R&S FSL
1300.2519.12 4.420 E-11
Signal Field Content (Demod Settings dialog box, IEEE 802.11a, g (OFDM), j and n)
Activates or deactivates the decoding of the captured burst data.
On Only the bursts are included in the results analysis whose modulation format specified
in the signal symbol field matches the modulation format specified in the Analyze
PSDU Mod field.
Off The data is demodulated according to the modulation scheme specified in the
Demodulator field. If any of the analyzed data has a modulation different to that
specified the results will be of limited use.
Remote: DEM:FORM:SIGS ON
Use Header Content (Demod Settings dialog box, IEEE 802.11b, g – Single Carrier)
Activates or deactivates the PLCP header field decoding of the captured burst data.
On Only the bursts are included in the results analysis whose modulation format specified
in the signal symbol field matches the modulation format specified in the Analyze
PSDU Mod field.
Off The data is demodulated according to the modulation scheme specified in the
Demodulator field. If any of the analyzed data has a modulation different to that
specified the results will be of limited use.
Remote: DEM:FORM:AUT ON
Burst Type (Demod Settings dialog box, IEEE 802.11a, g (OFDM, Single Carrier), j and n)
Specifies the type of burst to be included in measurement analysis. Only one burst type can be
selected for the measurement results. The following burst types are supported:
Direct Link Burst
IEEE 802.11a, j, n
OFDM
IEEE 802.11g
Long DSSS–OFDM
IEEE 802.11g
Short DSSS–OFDM
IEEE 802.11g
Long PLCP
IEEE 802.11g
Short PLCP
IEEE 802.11g
Remote: DEM:FORM:BAN:BTYPe 'DIRECT'
Preamble Type (Demod Settings dialog box, IEEE 802.11b)
Specifies the type of burst which should be included in measurement analysis. The following
burst types are supported: Short PLCP, Long PLCP.
Remote: DEM:FORM:BAN:BTYPe 'SHORT'
To Next Page
Loading...
