R&S FSL WLAN TX Measurements (Option K91 / K91n)
1300.2519.12 4.421 E-11
Auto Demodulation
Activates or deactivates the automatic detection of the modulation. If activated, the modulation
applied to the input data is determined from the modulation type of the first complete burst within
the captured data. This option automatically activates the Signal Field Content option.
Remote: DEM:FORM:AUT ON
Analyze PSDU Mod
Specifies the modulation of the bursts to be analyzed. Only bursts using the selected modulation
are considered in measurement analysis. This option is only available if the Signal Field
Content or the Use Header Content option is activated.
Remote: DEM:FORM:AUT ON
Demodulator
Specifies the modulation to be applied to the measured data. If the captured data uses a
different modulation scheme than specified by this field the results will be of limited use. This
field is only available if the Signal Field Content or the Use Header Content option is
deactivated.
Remote: DEM:FORM:BAN 'QAM16'
PPDU Frame Format (Demod Settings dialog box, IEEE 802.11n)
PPDU Frame Format specifies the type of PHY Protocol Data Unit (PPDU) which should be
included in measurement analysis. The following PPDU formats are supported:
– Mixed 20 MHz
– Green Field 20 MHz
Remote: DEM:FORM:BAN:BTYP 'MM20'
Auto Guard (Demod Settings dialog box, IEEE 802.11n)
Specifies whether the Guard interval of the measured data should be automatically detected or
not. When Auto Guard Interval is set to ON then the Guard Interval is detected from the input
signal .
When Use Auto Guard Interval is set to OFF then guard interval of the input signal can be
specified with the Guard Interval parameter.
Remote: CONF:WLAN:GTIM:AUTO ON
Guard Interval (Demod Settings dialog box, IEEE 802.11n)
Specifies the guard interval of the input signal.
When Auto Guard Interval is set to ON then Guard Interval is read only and display the detected
guard interval.
Remote: CONF:WLAN:GTIM SHOR
To Next Page
Loading...
