R&S FSL WLAN TX Measurements (Option K91 / K91n)
1300.2519.12 4.423 E-11
Channel Estimation (Demod Settings dialog box, IEEE 802.11a, g (OFDM), j, n)
Specifies how accurately the EVM results are calculated.
Preamble
The channel estimation is performed in the preamble as required in the
standard.
Payload
The channel estimation is performed in the payload.
Remote: DEM:CEST ON
Payload Length (Demod Settings dialog box, IEEE 802.11b, g)
Specifies the number of symbols, bytes or duration of a burst to be considered in measurement
analysis. This field is only available if the Equal Burst Length option is activated.
Remote: DEM:FORM:BAN:DBYTes:MIN 16
Remote: DEM:BAN:DUR:MIN 45
Min Payload Length (Demod Settings dialog box, IEEE 802.11b, g)
Specifies the minimum number of symbols, bytes or duration of a burst to be considered in
measurement analysis. This field is only available if the Equal Burst Length option is
deactivated.
Remote: DEM:FORM:BAN:DBYTes:MIN 16
Remote: DEM:BAN:DUR:MIN 45
Max Payload Length (Demod Settings dialog box, IEEE 802.11b, g)
Specifies the maximum number of symbols, bytes or duration of a burst to be considered in
measurement analysis. This field is only available if the Equal Burst Length option is
deactivated.
Remote: DEM:FORM:BAN:DBYTes:MAX 1300
Remote: DEM:BAN:DUR:MAX 1300
Phase (Demod Settings dialog box)
Activates or deactivates the compensation for phase error. If activated, the measurement results
are compensated for phase error on a per–symbol basis.
Remote: TRAC:PHAS 1
Timing (Demod Settings dialog box)
Activates or deactivates the compensation for timing error. If activated, the measurement results
are compensated for timing error on a per–symbol basis.
Remote: TRAC:TIME ON
To Next Page
Loading...
