R&S FSL WLAN TX Measurements (Option K91 / K91n)
1300.2519.12 4.431 E-11
Carrier Selection (IEEE 802.11a, g, j, n – OFDM)
Opens a dialog box to select the carrier for data display. Either a specific carrier number, pilots
only or all carriers can be selected.
Remote: CONF:BURS:CONS:CARR:SEL –26
Spectrum
Opens a submenu for frequency measurements.
Spectrum Flatness (IEEE 802.11a, g, j, n – OFDM)
Sets the Spectrum Flatness result display.
This result display shows the spectrum flatness and group delay values recorded on a per–
carrier basis over the full set of measured data. An average trace is also displayed for each of
the result types. An upper and lower limit line representing the limits specified for the selected
standard are displayed and an overall pass/fail status is displayed for the obtained (average)
results against these limit lines.
Remote: CONF:BURS:SPEC:FLAT
To Next Page
Loading...
