R&S FSL WLAN TX Measurements (Option K91 / K91n)
1300.2519.12 4.435 E-11
– IEEE 802.11b or g (Single Carrier)
The results are grouped by burst.
Remote: CONF:BURS:STAT:BSTR
Signal Field (IEEE 802.11a, g, j, n – OFDM),
PLCP Header (IEEE 802.11b, g – Single Carrier)
Sets the Signal Field result display or the PLCP Header result display, depending on the
selected standard.
Signal Field
This result display shows the decoded data from the signal field of the burst. Therefore it is only
available, if, in the Demod Settings dialog box, the Signal Field Content option is activated.
To Next Page
Loading...
