Rohde & Schwarz R&S FSL3 - Page 627

WiMAX, WiBro Measurements (Options K92/K93) R&S FSL
1300.2519.12 4.442 E-11
To open the measurement menu

If the WiMAX mode is not the active measurement mode, press the MODE key and activate the
WiMAX option.
 If the WiMAX mode is already active, press the MENU or MEAS key.
The measurement menu is displayed. .
 To exit the WiMAX measurement mode, select another option. For details refer also to section
"Measurement Mode Selection – MODE Key" on page 4.129.
Menu and softkey description
– "Softkeys of the WiMAX menu (WiMAX mode)" on page 4.448
– "Softkeys of the sweep menu (WiMAX mode)" on page 4.486
– "Softkeys of the marker menu (WiMAX mode)" on page 4.487
– "Softkeys of the marker–> menu (WiMAX mode)" on page 4.488
– "Softkeys of the lines menu (WiMAX mode)" on page 4.488
– "Softkeys of the trace menu (WiMAX mode)" on page 4.489
The file, setup, and print menus are provided as described for the base unit. For details refer to the
corresponding menu descriptions. The span and bandwidth menus are not available in the WiMAX
mode.
The FREQ, AMPT and TRIG keys open the General Settings or the Demod Settings dialog box. For
details refer to the Settings General/Demod softkey description (measurement menu).
Further information topics
– "Measurements and result displays" on page 4.442
– "Current restrictions to the IEEE 802.16e–2005 OFDMA/WiBro signal to be analyzed" on page
4.443
– "Title bar information" on page 4.448
– "Status bar information" on page 4.448
Tasks topics
– "To transfer the current R&S SMU WiMAX setting via LAN" on page 4.447
Measurements and result displays
The WiMAX IEEE 802.16 OFDM, OFDMA Measurements option provides two main measurement
types:
• IQ measurements (based on captured IQ data)
– Power vs Time (see PVT softkey)
– EVM vs Symbol, EVM vs Carrier (see EVM vs Symbol/Carrier softkey)
– Phase vs Preamble, Frequency vs Preamble (see Error Frequency/Phase softkey)
– Spectrum Flatness (see Spectrum Flat./Diff./Group Delay softkey)
– Spectrum Group Delay (see Spectrum Flat./Diff./Group Delay softkey)
– Spectrum Flatness Adjacent Carrier Power Difference (see Spectrum Flat./Diff./Group Delay
softkey)