WiMAX, WiBro Measurements (Options K92/K93) R&S FSL
1300.2519.12 4.448 E-11
4. Press the More softkey to change into the side menu.
5. Press the File Manager softkey to open the File Manager.
6. Under Folders, select the SMU entry.
7. Under Files, select the Current SMU WiMAX Settings entry using the RIGHTARRROW key.
8. Press the Recall softkey.
The selected WiMAX setting file is transferred from the R&S ´SMU to the R&S FSL.
Title bar information
The title bar displays the following information:
• standard applicable to the current measurement
Status bar information
The status bar displays the following information:
• parameter values
If a parameter in a settings dialog box is selected, the minimum and maximum values for the
selected parameter are displayed.
If a Boolean parameter in a dialog box is selected, the minimum and maximum values are displayed
as N/A for not applicable.
• measurement status
During the measurement, the current measurement status along with detailed information about the
progress is displayed.
• error messages (with red background), for details refer to chapter "Error Messages".
• warning messages (with blue background), for details refer to chapter "Error Messages".
Softkeys of the WiMAX menu (WiMAX mode)
The following table shows all softkeys available in the WiMAX menu. It is possible that your instrument
configuration does not provide all softkeys. If a softkey is only available with a special option, model or
(measurement) mode, this information is delivered in the corresponding softkey description.
Menu / Command Command
Settings General/Demod
Display Graph/List
PVT Settings General/Demod
Display Graph/List
Full Burst
Start End
Burst Selection
Full Subframe
Rising/Falling
More
Gating Settings On/Off
To Next Page
Loading...
