EasyManua.ls Logo

Rohde & Schwarz R&S FSL3 - Page 636

Rohde & Schwarz R&S FSL3
1734 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
R&S FSL WiMAX, WiBro Measurements (Options K92/K93)
1300.2519.12 4.451 E-11
Pane Field/List Standard Restrictions
IQ Settings Swap IQ
Result Settings RSSI, CINR avg.
List Results Unit IEEE 802.16–2004 OFDM
Setup SMU Address IEEE 802.16e–2005 OFDMA/WiBro
I
n the Demod Settings dialog box, the settings associated with the signal modulation are
modified. The content of the Demod Settings dialog box depends on the selected standard:
IEEE 802.16–2004 OFDM
The settings under Burst to Analyze specify the characteristics of the bursts to be considered
in the measurement results. Only the bursts which meet the criteria specified in this group will
be included in measurement analysis. The settings under Tracking allow various errors in
measurement results to be compensated for.
IEEE 802.16e–2005 OFDMA/WiBro
The Demod Settings dialog box contains the three tabs. Use the left/right arrow keys to
navigate between the tabs.
On the Demod Settings tab, the channel estimation range is set. The settings under Bursts to
Analyze specify the characteristics of the bursts to be considered in the measurement results.
The settings under Tracking allow various errors in measurement results to be compensated
for.
On the Frame Global tab, the common settings associated with the frame to be analyzed can
be modified.
On the Frame Config tab, the settings associated with the frame configuration can be modified.
The Zone/Segment List and the Burst List are displayed. The content of the selected list is
graphically displayed under The content of the selected list is graphically displayed under the
Zone/Segment Map and the Burst Map respectively. To edit Frame Config tab, softkeys are
available (see the table below).
The Demod Settings dialog box contains the following elements:
Tab/Pane Field/List or Softkey Standard Restrictions
Demod Settings
Burst to Analyze Burst Type IEEE 802.162004 OFDM
Link Mode IEEE 802.16–2004 OFDM
Use FCH Content IEEE 802.16–2004 OFDM
Mod. Detection IEEE 802.16–2004 OFDM
Demodulator IEEE 802.16–2004 OFDM
Subchannelization IEEE 802.16–2004 OFDM
Index IEEE 802.162004 OFDM
UL Phys. Modifier IEEE 802.162004 OFDM
Equal Burst Length IEEE 802.16–2004 OFDM
Data Symbols IEEE 802.162004 OFDM
Min Data Symbols IEEE 802.162004 OFDM
Max Data Symbols IEEE 802.162004 OFDM
Channel Estimation IEEE 802.162004 OFDM
Tracking Phase IEEE 802.16–2004 OFDM
Timing IEEE 802.16–2004 OFDM

Table of Contents

Related product manuals