WiMAX, WiBro Measurements (Options K92/K93) R&S FSL
1300.2519.12 4.456 E-11
Auto Level Time (General Settings dialog box)
Specifies the sweep time used for the automatic level measurements.
Remote: CONF:POW:AUTO:SWE:TIME 200MS
R
ef Level (General Settings dialog box)
Specifies the reference level used for measurements. If the reference level is modified, the
signal level is updated accordingly (depending on the currently selected standard and
measurement type). This field is only editable if the Auto Lev option is deactivated.
Remote: DISP:TRAC:Y:RLEV?
Attenuation (General Settings dialog box)
Specifies the settings for the attenuator. This field is only editable if the Auto Lev option is
deactivated. If the Auto Lev option is activated, the RF attenuator setting is coupled to the
reference level setting.
Remote: INP:ATT 30dB
Swap IQ (General Settings dialog box)
Activates or deactivates the inverted I/Q modulation.
On I and Q signals are interchanged.
Off Normal I/Q modulation.
Remote: SWAP ON
RSSI, CINR avg. (General Settings dialog box)
Specifies the mean and standard deviation for the RSSI and CINR results (see IEEE Std
802.16–2004 "8.3.9.2 RSSI mean and standard deviation'', "8.3.9.3 CINR mean and standard
deviation'').
Remote: CONF:WIM:AVER 0.1
List Results Unit (General Settings dialog box, IEEE 802.16–2004 OFDM)
Specifies the units for the results in the results summary table.
Remote: UNIT:TABL DB
SMU Address (General Settings dialog box, IEEE 802.16e–2005 OFDMA/WiBro)
Specifies the TCP/IP address of an external R&S SMU signal generator connected via TCP/IP.
This enables the R&S FSL to download the frame zone setup directly.
Remote: SYST:COMM:TCP:ADDR 192.168.1.1
To Next Page
Loading...
