WiMAX, WiBro Measurements (Options K92/K93) R&S FSL
1300.2519.12 4.458 E-11
rate B) and (modulation format C, coding rate D), the signal to be analyzed must hold the
f
ollowing condition in order to produce correct measurement results:
[A == C
B == D]
Remote: DEM:FORM:BAN '16QAM1/2
Subchannelization (Demod Settings dialog box, IEEE 802.16–2004 OFDM)
Activates or deactivates the subchannelization, if the Up Link mode is set (see Link Mode
field). If activated, the subchannel index of uplink bursts is analyzed, defined by the Index field.
Remote: SUBC:STAT ON
Index (Demod Settings dialog box, IEEE 802.16–2004 OFDM)
Defines the subchannelization index of uplink bursts to be analyzed. Subchannelization index 16
is the default subchannel with full occupation.
Remote: SUBC 12
UL Phys. Modifier (Demod Settings dialog box, IEEE 802.16–2004 OFDM)
Specifies a common UL physical modifier for all uplink bursts.
Remote: SUBC:ULPH 1
Equal Burst Length (Demod Settings dialog box, IEEE 802.16–2004 OFDM)
Activates or deactivates the burst selection for measurement analysis according to the range or
specific number of data symbols/bytes.
On Only bursts with exactly the number of symbols specified in the
Data Symbols field are considered for measurement analysis.
Off Only bursts within the range of data symbols specified by the
Min Data Symbols and Max Data Symbols fields are
considered for measurement analysis.
Remote: DEM:FORM:BAN:SYMB:EQU ON
Data Symbols (Demod Settings dialog box, IEEE 802.16–2004 OFDM)
Specifies the number of symbols that a burst must have to be considered for measurement
analysis. This field is only available if the Equal Burst Length option is activated.
Remote: DEM:FORM:BAN:SYMB:MIN 16
Min Data Symbols (Demod Settings dialog box, IEEE 802.16–2004 OFDM)
Specifies the minimum number of data symbols that a burst must have to be considered in
measurement analysis. This field is only available if the Equal Burst Length option is
deactivated.
Remote: DEM:FORM:BAN:SYMB:MIN 16
To Next Page
Loading...
