WiMAX, WiBro Measurements (Options K92/K93) R&S FSL
1300.2519.12 4.460 E-11
Uplink (UL) (Demod Settings dialog box, IEEE 802.16e–2005 OFDMA/WiBro)
Displays the channel estimation performed for uplink signals.
This field is for information purposes only as channel estimation for uplink signals are always
performed in payload only (payload comprises pilots and data).
Modulation Analysis Scope (Demod Settings dialog box, IEEE 802.16e–2005 OFDMA/WiBro)
Displays the modulation formats to be analyzed.
This field is for information purposes only as all detected modulation schemes are analyzed.
Demodulator (Demod Settings dialog box, IEEE 802.16e–2005 OFDMA/WiBro)
Displays the modulation scheme detected in the analyzed signal. For signals using multiple
modulation schemes, the modulation scheme with the highest data rate is displayed. The field
also indicates the limits that are applied to the EVM results in the table or results.
This field is for information purposes only.
Remote: DEM:FORM:BAN?
Pilots for Tracking DL (Demod Settings dialog box, IEEE 802.16e–2005 OFDMA/WiBro)
Specifies how, for downlink signals, the pilot sequence is determined for tracking purposes.
According to Standard
The pilot sequence is computed according to the standard.
Detected
The pilot sequence uses the values detected in the signal.
Remote: TRAC:PIL DET
Pilots for Tracking UL (Demod Settings dialog box, IEEE 802.16e–2005 OFDMA/WiBro)
Displays how, for uplink signals, the pilot sequence is determined for tracking purposes.
This field is for information purposes only as tracking is performed according to the selected
standard.
FFT start offset rel to CP center (Demod Settings dialog box, IEEE 802.16e–2005 OFDMA/WiBro)
Adds an offset to the FFT starting point determined by the application.
The setting range is from –100% to +100% of the cyclic prefix (CP) length. In the case of 0%,
the optimal FFT starting point, determined by the application, is used. This is the default setting.
Remote: FFT:OFF 0
File Name (Demod Settings dialog box, IEEE 802.16e–2005 OFDMA/WiBro)
Displays the name of the loaded *.WIMAX settings file. If no file is loaded the '….' is displayed.
This field is for information purposes only.
To Next Page
Loading...
