R&S FSL WiMAX, WiBro Measurements (Options K92/K93)
1300.2519.12 4.461 E-11
IDCell (Demod Settings dialog box, IEEE 802.16e–2005 OFDMA/WiBro)
Specifies the downlink IDCell number and affects the definition of the preamble sequence (in
conjunction with the used segments according to the Used Subchannel Bitmap setting), the
pilot sequence of the first zone and the subchannel definition of the first zone.
Remote: CONF:WIM:DLSF:IDC 0
Preamble Mode (Demod Settings dialog box, IEEE 802.16e–2005 OFDMA/WiBro)
Specifies how the preamble index is calculated.
Auto The preamble index is automatically calculated according to the IDCell and Used
Subchannel Bitmap parameters.
User
The preamble index can be specified manually, i.e. the preamble pattern is chosen
according to the standard using the Preamble Index parameter.
Remote: CONF:WIM:DLSF:PRE:MODE AUTO
Preamble Index (Demod Settings dialog box, IEEE 802.16e–2005 OFDMA/WiBro)
Specifies the preamble pattern (according to the standard) to be used, if the Preamble Mode
parameter is set to User.
Remote: CONF:WIM:DLSF:PRE:IND 31
Used Subchannel Bitmap (Demod Settings dialog box, IEEE 802.16e–2005 OFDMA/WiBro)
Assigns subchannel groups to segments, see [802.16e–2005], page 360, table 268a
"Subchannel index of the six subchannel groups". This table defines how many subchannels are
available for the Burst List (Frame Config tab) belonging to the corresponding segment of a
DL–PUSC zone (with Use All Subchannels being false). In the burst list – corresponding to the
segment – this selection controls the height of the white area in the burst map.
Remote: CONF:WIM:DLSF:SEGM1 63
Frame Number (Demod Settings dialog box, IEEE 802.16e–2005 OFDMA/WiBro)
Specifies the number of the frame to be analyzed. For UL subframe analysis, the frame number
must be constant for the signal to be analyzed.
Remote: CONF:WIM:ULSF:FRAM 0
Allocated Subchannel Bitmap (Demod Settings dialog box, IEEE 802.16e–2005 OFDMA/WiBro)
Specifies the subchannels to be analyzed.
This parameter is for information purposes only as all subchannels are used in the UL subframe.
To Next Page
Loading...
