WiMAX, WiBro Measurements (Options K92/K93) R&S FSL
1300.2519.12 4.462 E-11
List Zone/Burst (IEEE 802.16e–2005 OFDMA/WiBro)
Sets the focus on the Zone/Segment List or the Burst List to enter and modify data. To insert,
copy, and delete rows, use the softkeys available with the Frame Config tab.
The content of the selected list is graphically displayed under the Zone/Segment Map and the
Burst Map respectively.
The Zone/Segment List contains the following columns:
Column Description
ID Provides a unique ID for the zone. This parameter is read only. If there are any errors in the
zone/segment configuration, the background is displayed in red color.
Bursts
Pressing the rotary knob or the ENTER key with focus on this field changes the focus to the
Burst List and displays the Burst Map.
Analyze Defines the zone/segment to be analyzed. Only one zone/segment can be selected for analysis
at any given time.
Zone Defines the zone type. The following types are supported: DL–PUSC, DL–FUSC, UL–PUSC
Segment Defines the segment for a DL–PUSC zone.
For DL–FUSC zones, this parameter has no effect.
Length Defines the length in OFDMA symbols of the zone.
The zone length must be a multiple of the symbol numbers per slot. If this is not the case, an
error message is displayed in the status bar and the measurement does not start.
Offset Defines the offset in OFDMA symbols from the start of the subframe.
The first DL–PUSC zone starts with 1. The first UL–PUSC zone starts with 0.
PermBase Specifies the permbase that is required for the calculation of the subchannel – physical carrier
assignment permutation.
PRBS_ID Specifies the permbase ID that is required for the calculation of the pilot sequence.
Fig. 4-54 Definition of the Zone Offset [green arrow] and the Zone Length [violet arrow] parameters
from the Zone/Segment List
To Next Page
Loading...
