R&S FSL WiMAX, WiBro Measurements (Options K92/K93)
1300.2519.12 4.463 E-11
The Burst List contains the following parameters, depending on the zone selection:
Column Description Zone
restrictions
ID Provides a unique ID for the burst. This parameter is read only. The background
color of this parameter reflects the modulation of the burst. If there are any errors in
the burst configuration then the background of this item will be red.
Modulation
Defines the modulation format of the burst. In the Burst Map, identical modulation
formats are displays in the same color.
No. of Subch. Defines the number of logical subchannels occupied by the burst. DL_FUSC,
DL_PUSC
No. of Symb. Defines the number of OFDMA symbols occupied by the burst.
It must be a multiple of the symbol numbers per slot. If this is not the case, an error
message is displayed in the status bar and the measurement does not start.
DL_FUSC,
DL_PUSC
Duration
[Slots]
Specifies the unit of time for the allocating bandwidth. UL_PUSC
Auto If selected, the Offset Subch. and the Offset Symb. parameters are set
automatically.
UL_PUSC
Offset Subch. Defines the offset in logical subchannels from subchannel 0.
Offset Symb. Defines the offset in OFDMA symbols. It must be a multiple of the number of
symbols per slot. If this is not the case, an error message is displayed in the status
bar and the measurement does not start.
The start of the zone defines symbol 0.
Power[dB] Defines the boosting factor of the burst.
Burst Type Defines the burst type from the protocol layer perspective. DL_FUSC,
DL_PUSC
Fig. 4-55 Definition of the Burst Offset [green arrows] and the Burst Length [violet arrows]
parameters from the Burst List
The Zone/Segment Map and the Burst Map display panes are located at the bottom of the
Frame Config tab. They display a graphical view of the selected Zone/Segment List.
– Zone/Segment Map
Displays a graphical view of the selected Zone/Segment List.
To Next Page
Loading...
