WiMAX, WiBro Measurements (Options K92/K93) R&S FSL
1300.2519.12 4.474 E-11
– Constellation vs Carrier (IEEE 802.16–2004 OFDM)
This result display shows the in–phase and quadrature phase results over the full range of the
measured input data plotted on a per–carrier basis. The magnitude of the in–phase and
quadrature part is shown on the y–axis, both are displayed as separate traces (I–> trace 1, Q–>
t
race 2).
Remote: CONF:BURS:CONS:CSYM (Constellation vs Symbol)
Remote: CONF:BURS:CONS:CCAR (Constellation vs Carrier)
Carrier Selection (IEEE 802.16–2004 OFDM)
Opens a dialog box to select the carrier for data display. Either a specific carrier number, pilots
only or all carriers can be selected.
Remote: CONF:BURS:CONS:CARR:SEL –26
Constell Selection (IEEE 802.16e–2005 OFDMA/WiBro)
Opens a dialog box for filtering the displayed results. The results may be filtered by any
combination of modulation, burst, symbol, or carrier. If the constellation selection parameters are
changed, the result display is updated accordingly.
Remote: CONF:BURS:CONS:SYMB:SEL 1 (symbol)
Remote: CONF:BURS:CONS:FORM:SEL QPSK (modulation)
Remote: CONF:BURS:CONS:BURS:SEL 1 (burst)
Y–Axis/Div (EVM vs Symbol/Carrier, Error Frequency/Phase)
Opens a dialog box to modify the y–axis settings:
Auto Scaling
If activated, the scaling of the y–axis is calculated automatically.
Per Division Specifies the scaling to be used if Auto Scaling is deactivated.
Unit
Specifies the y–axis unit.
To Next Page
Loading...
