R&S FSL WiMAX, WiBro Measurements (Options K92/K93)
1300.2519.12 4.475 E-11
This softkey is only available for the above mentioned measurements if trace data are displayed.
Remote: DISP:WIND2:TRAC1:Y:AUTO ON (Auto Scaling)
Remote: DISP:WIND2:TRAC1:Y:PDIV 2 (Per Division)
Remote: UNIT:EVM PCT (Unit – EVM vs Symbol/Carrier)
Remote: UNIT:PRE HZ (Unit – Error Frequency/Phase)
Spectrum
Opens a submenu for frequency measurements.
Spectrum Flat./Diff./Group Delay
Sets the Spectrum Flatness result displays in graphical form (Display Graph selected), or in
tabular form (Display List 1/2 selected).
– Spectrum Flatness and Spectrum Flatness Group Delay (IEEE 802.16–2004 OFDM)
These result displays show either the Spectrum Flatness or the Group Delay values recorded
on a per–carrier basis over the full set of measured data. A minimum, average and maximum
trace are displayed for each of the result types. If the Spectrum Flatness result display is
selected an upper and lower limit line representing the limits specified for the selected standard
are displayed. An overall pass/fail status is displayed for the obtained (average) results against
these limit lines.
To Next Page
Loading...
