R&S FSL WiMAX, WiBro Measurements (Options K92/K93)
1300.2519.12 4.485 E-11
– IEEE 802.16e–2005 OFDMA/WiBro
This result display provides information about the bursts from the analyzed zone, i.e.
modulation of the burst, power boosting information, EVM of the burst. Each analyzed zone will
produce a set of burst results.
Remote: CONF:BURS:STAT:BSUM
Bit Selection (IEEE 802.16e–2005 OFDMA/WiBro)
Opens a dialog box for filtering the displayed results. The results may be filtered by any
combination of modulation, symbol or burst. If the bit selection parameters are changed, the
result display is updated accordingly.
This softkey is only available if the Bitstream measurement (Bitstream softkey) is selected.
Remote: CONF:BURS:BSTR:SYMB:SEL 1 (symbol)
Remote: CONF:BURS:BSTR:FORM:SEL QPSK (modulation)
Remote: CONF:BURS:BSTR:BURS:SEL 1 (burst)
File Manager (IEEE 802.16e–2005 OFDMA/WiBro)
Opens the File Manager dialog box. The File Manager provides the possibility to transfer
WiMAX settings from an R&S SMU signal generator via LAN. For step–by–step instructions see
"To transfer the current R&S SMU WiMAX setting via LAN" on page 4.447. The File Manager
also offers some general file management support.
The File Manager writes into the directory C:\R_S\Instr\user\WMAN and its subdirectories or a
USB memory stick only.
Under File Types, filter the displayed files by selecting:
All (*.*)
All file types are displayed. Use this selection to perform general file
management tasks.
SMU WiMax
Only files with the extension WiMAX are displayed.
To Next Page
Loading...
