WiMAX, WiBro Measurements (Options K92/K93) R&S FSL
1300.2519.12 4.486 E-11
Depending on the focus, the following softkeys are provided:
– Recall
– New Folder
– Copy
– Paste
– Rename
– Delete File
For further information refer to section "Instrument Functions – Basic Settings", "Saving and
Recalling Settings Files – FILE Key".
Softkeys of the sweep menu (WiMAX mode)
The following table shows all softkeys available in the sweep menu in WiMAX mode (SWEEP key). It is
possible that your instrument configuration does not provide all softkeys. If a softkey is only available
with a special option, model or (measurement) mode, this information is delivered in the corresponding
softkey description.
Command
Run Single/Cont
Auto Level
Refresh
Run Single/Cont
Selects the sweep mode.
Single
single sweep mode
Cont
continuous sweep mode
A single measurement will complete once the requested number of bursts have been obtained
or a single sweep has been completed, depending on the measurement settings. If a
measurement is completed in continuous mode, a new measurement will be started.
If a measurement is started while another measurement is in progress, the first measurement
will be aborted and the new measurement started immediately.
Remote: INIT:CONT OFF (single sweep mode)
Remote: INIT:CONT ON (continuous sweep mode)
Auto Level
Starts an automatic level detection measurement. After the automatic level detection has been
completed, the trace is displayed in the Magnitude Capture Buffer display.
If this softkey is pressed while a measurement is running, the current measurement is aborted
and the automatic level detection measurement is started. If the aborted measurement was a
continuous measurement, it is resumed after the automatic level detection is completed.
Remote: CONF:POW:AUTO ON
To Next Page
Loading...
