Instrument Setup and Interface Configuration - SETUP Key R&S FSL
1300.2519.12 4.492 E-11
Instrument Setup and Interface Configuration - SETUP Key
The SETUP key is used to set or display the default settings of the instrument: reference frequency,
noise source, level correction values, date, time, LAN interface, firmware update and enabling of
options, information about instrument configuration and service support functions. For further details
refer also to the Quick Start Guide, chapter 2 "Preparing for Use".
To open the setup menu
Press the SETUP key.
The setup menu is displayed.
Menu and softkey description
– "Softkeys of the setup menu" on page 4.492
To display help to a softkey, press the HELP key and then softkey for which you want to display help.
To close the help window, press the ESC key. For further information refer to section "How to use the
Help System".
Softkeys of the setup menu
The following table shows all softkeys available in the setup menu. It is possible that your instrument
configuration does not provide all softkeys. If a softkey is only available with a special option, model or
(measurement) mode, this information is delivered in the corresponding softkey description.
Menu Command Submenu / Command Submenu / Command Command
Reference Int/Ext
Transducer Active On/Off
Edit Insert Line
Delete Line
Edit Name
Edit Unit
Edit Value
Interpolation Lin/Log
Save Factor
New same contents as Edit menu
Copy to same contents as Edit menu
Delete
Ref Level Adjust Man/Auto
Show Directory
IF Output
Noise Src On/Off
Alignment Self Align
Show Align Results
Corr Data On/Off
General Setup Configure Network
To Next Page
Loading...
