Measurement Documentation - PRINT Key R&S FSL
1300.2519.12 4.522 E-11
Select Object
For details see Select Object softkey of the setup menu.
This softkey is available from firmware version 1.10.
Predefined Colors
For details see Predefined Colors softkey of the setup menu.
This softkey is available from firmware version 1.10.
User Defined Colors
For details see User Defined Colors softkey of the setup menu.
This softkey is available from firmware version 1.10.
Set to Default
For details see Set to Default softkey of the setup menu.
This softkey is available from firmware version 1.10.
Comment
Opens dialog box to enter a comment. Max. 120 characters are allowed. 60 characters fit in one
line. In the first line, at any point a manual line-feed can be forced by entering "@".
Date and time are inserted automatically. The comment is printed below the diagram area, but
not displayed on the screen. If a comment should not be printed, it must be deleted.
For details on the alphanumeric entries refer to the Quick Start Guide, chapter 4 "Basic
Operations".
This softkey is available from firmware version 1.10.
Install Printer
Opens the Printers and Faxes window to install a new printer. All printers that are already
installed are displayed. For details refer to the Quick Start Guide, appendix A, "Printer Interface".
To Next Page
Loading...
