Rohde & Schwarz R&S FSL3

To Next Page

To Previous Page

R&S FSL DIAGnostic Subsystem

1300.2519.12 6.125 E-11

IAGnostic<1|2>:SERVice:SFUNction

This command activates a service function which can be selected by indicating the five

parameters: function group number, board number, function number, parameter 1 and

parameter 2 (see service manual). The contents of the parameter string are identical to the code

to be entered in the edit dialog box of manual operation.

The entry of a service function is accepted only if the system password level 1 or level 2 has

been entered previously (SYSTem:PASSword[:CENable]).

The numeric suffixes <1|2> are irrelevant for this command.

Parameter

Example

DIAG:SERV:SFUN 2.0.2.12.1

Characteristics

*RST value: -

SCPI: device-specific

Mode

all

DIAGnostic<1|2>:SERVice:STESt:RESult?

This command reads the results of the self test out of the instrument. The lines of the result

table are output as string data separated by commas:

"Total Selftest Status: PASSED","Date (dd/mm/yyyy): 09/07/2004

TIME: 16:24:54","Runtime: 00:06","...