Rohde & Schwarz R&S FSL3 - Page 925

MMEMory Subsystem R&S FSL
1300.2519.12 6.166 E-11
Characteristics
*RST value: OFF
SCPI: device-specific
Mode
all
MMEMory:SELect[:ITEM]:TRACe[:ACTive]
This command includes the active traces in the settings file to be stored/loaded. Active traces
are all traces whose state is not blank.
Parameter
ON | OFF
Example
MMEM:SEL:TRAC ON
Characteristics
*RST value: OFF, i.e. no traces will be stored
SCPI: device-specific
Mode
all
MMEMory:SELect[:ITEM]:TRANsducer:ALL
This command includes all transducer factors and sets in the settings file to be stored/loaded.
This command is available from firmware version 1.10.
Parameter
ON | OFF
Example
MMEM:SEL:TRAN:ALL ON
Characteristics
*RST value: ON
SCPI: device-specific
Mode
all
MMEMory:STORe<1|2>:LIST
This command stores the current list evaluation results in a *.dat file. The file consists of a data
section containing the list evaluation results.
The numeric suffixes <1|2> are not relevant.
This command is an event and therefore has no *RST value and no query.
This command is available from firmware version 1.80.
Example
MMEM:STOR:LIST 'test'
Stores the current list evaluation results in the a test.dat file.