Rohde & Schwarz R&S NRP - Page 264

R&S NRP Remote Control - Commands
1144.1400.12 6.89 E-3
Questionable Calibration Status Register
The EVENt register and the CONDition register contain information as to whether the zero offset of a
sensor is still valid.
The Questionable Calibration Status Register can be read by the following commands:
STATus:QUEStionable:CALibration[:SUMMary]:CONDition?
andSTATus:QUEStionable:CALibration[:SUMMary][:EVENt]?
Table 6-29 Meaning of bits used in the Questionable Calibration Status Register
Bit
No.
Meaning
0
Not used
1 Sensor A Calibration
Zeroing of sensor A was not successful.
2 Sensor B Calibration
Zeroing of sensor B was not successful.
3 Sensor C Calibration
Zeroing of sensor C was not successful.
4 Sensor D Calibration
Zeroing of sensor D was not successful.
5 to
14
Not used
15
Bit 15 will never be used.
Use of Status Reporting System
For an efficient use of the status reporting system, the information it contains has to be transferred to
the controller and further processed. There are various methods which are described in the following.