Rohde & Schwarz R&S NRP - Page 271

Remote Control - Commands R&S NRP
1144.1400.12 6.96 E-3
SYSTem:ERRor:EXTended[:STATe][?] <boolean>
SYST:ERR:EXT ON activates extended error messages (SYST:ERR?). The location of errors in the
parsed command strings is also shown.
*RST-Wert: OFF
SYSTem:KEY <NR1> | <character_value>
This command is used for testing purposes only and simulates a single stroke of an R&S NRP
front-panel key.
The key to be simulated is described either in plain text (<character_value>) or by a key code
(<NR1>) (Æ Table 6-32).
Table 6-32: Valid parameter values for the SYSTem:KEY command.
Simulated front-panel key
<character_value> <NR1>
Softkey toggle 1 left
SK1L 1
Softkey toggle 1 right
SK1R 2
Softkey toggle 2 left
SK2L 3
Softkey toggle 2 right
SK2R 4
Softkey toggle 3 left
SK3L 5
Softkey toggle 3 right
SK3R 6
Softkey toggle 4 left
SK4L 7
Softkey toggle 4 right
SK4R 8
Softkey toggle 5 left
SK5L 9
Softkey toggle 5 right
SK5R 10
Softkey toggle 6 left
SK6L 11
Softkey toggle 6 right
SK6R 12
({PRE}SET )
PRESet 13
( ZERO/CAL )
ZERO 14
( FREQ )
FREQ 15
( Æ ) CONTrast 16
( Ø )
POWer 17