Remote Control - Commands R&S NRP
1144.1400.12 6.102 E-3
SYSTem:STANdard:PRESet <string>
The R&S NRP can be easily configured for measuring standardized signals (e.g. mobile radio
standards). For this purpose, the standards listed in the Annex (Æ Standard Configurations) are stored
in the R&S NRP. The SYST:STAN:PRES command sets the listed parameters and, if desired, also
configures front-panel display windows (if SYST:STAN:PWS ON).
*RST value: none
SYSTem:STANdard:PWSettings ON | OFF
If SYST:STAN:PRES <string> is used, SYST:STAN:PWS (Preserve Window Settings) determines
whether the window system is also configured with the calculate blocks (OFF) or whether exclusively
sensor parameters are set (ON).
*RST value: OFF
SYSTem:STANdard:TRIGger:SOURce INT | EXT
If SYST:STAN:PRES <string> is used, this command determines whether the sensors are set to
internal (INT) or external (EXT) triggering.
*RST value: INT
SYSTem:TIME[?] <hour>,<minute>,<second>
Parameter Value range
<hour> 0 ... 24
<minute> 0 ... 59
<second> 0 ... 59
Sets the time. Since the R&S NRP has no battery-backed clock, the time has to be reset if the clock
was not set after the last power-on of the R&S NRP. (Æ SYSTem:DATE[?]
<year>,<month>,<day>
).
SYSTem:VERSion?
Returns a string that contains the current version number of the SCPI standard.
To Next Page
Loading...
