Rohde & Schwarz R&S NRP - Page 329

Annex: Remote Control - Commands R&S NRP
1144.1400.12 Annex - I.10 E-2
BUS HOLD
INT
EXT
IMMTRIG:SOUR
*TRG, GET or TRIG:IMM
TRIG:IMM
or
Trigger signal
TRIG:IMM
INIT:CONT?
ABORT ON
OFF
MEASURING
WAIT_FOR_TRG
INITIATED
IDLE
*RST, PowerOn
INIT:IMM
INIT:CONT ON
?
Fig. I-1: Overview of basic relationships in the trigger state system
Fig. I-1: Overview of basic relationships in the trigger state system shows the basic structure of the
trigger system. It is possible to improve the sequence of measurement using the commands from the
TRIGger command system.