Operating the Instrument
R&S
®
RTO
80Getting Started 1316.0833.02 ─ 10
Automatic measurement
Starts an automatic measurement.
You can start up to 8 automatic measurements to run in parallel. The "Automatic meas-
urment" icon starts the measurements one after the other.
Tap the icon and then tap the diagram with the waveform to be measured.
To configure the measurement or select a different measurement type, tap the
icon in the "Measurement" result box.
Quick measurement
Performs a set of measurements on the selected waveform. You can configure up to 8
measurement types to be included in quick measurement.
Tap the icon and then tap the diagram with the waveform to be measured.
FFT
Transforms a waveform to the frequency spectrum by fast Fourier transformation
(FFT). The FFT trace appears in a new diagram.
Tap the icon and then tap diagram with the waveform to be transformed. The FFT dia-
gram is created from the selected waveform.
To configure FFT settings, double-tap the FFT diagram.
Select
Enables the select mode to move and modify objects on the touchscreen. The select
mode is activated automatically when an analyzing function is completed.
Delete
Removes zoom and histogram areas and their associated diagrams; measurement
areas and their associated results; and mask segments. The icon also switches off a
waveform.
Tap the icon and then tap the area or diagram to be deleted, or the waveform to be
switched off.
Save settings
Saves the current instrument settings in a saveset. The filename is created according
to the autonaming pattern. You can reload the saveset using the "Load saveset" tool-
bar icon, or using FILE > "Save/Recall" > "Settings".
Save screenshot
Saves a screenshot of the current display using the settings defined in "File" menu >
"Print Setup".
Clear screen results
Resets all measurement results including long term measurement and statistic results
and deletes the current measurement waveforms.
Autoset / Preset
Performs an autoset or a preset to a default state, respectively. The icons have the
same functionality as the corresponding keys on the front panel. They are useful when
you control the instrument remotely.
Toolbar
To Next Page
Loading...
