Operating the Instrument
R&S
®
RTO
85Getting Started 1316.0833.02 ─ 10
3. To change the size of the new diagram, drag its edge to the required position.
The diagram layout depends on the position where you drop the signal view, in relation
to an existing diagram.
Fig. 5-2: SmartGrid positions
1 = In the existing diagram, overlay of signal
2 = New diagram on the left or right
3 = New diagram above or below
4 = New diagram on top of the existing diagram
5 = XY-diagram
6 = YX-diagram
To switch off a waveform
► Do one of the following:
● Select the waveform, and then press the SIGNAL OFF key.
Working with Waveforms
To Next Page
Loading...
