Rohde & Schwarz R&S RTO Series - Displaying Results

Operating the Instrument
R&S
®
RTO
86Getting Started 1316.0833.02 ─ 10
● To switch off a minimized waveform, tap the "Close" icon in the upper right cor-
ner of the minimized signal view.
● Disable the "Show channel" setting in the "Vertical" dialog box.
● Tap the "Delete" icon (Recycle bin) in the toolbar, and then the waveform.
If several waveforms overlap or lie close together, the upper (selected) wave-
form is switched off.
5.5 Displaying Results
The results of automatic or cursor measurements, mask tests, and searches are dis-
played immediately in a result box.
There are three ways to display the results:
●
In a floating result box in front of the diagrams, which you can move on the display
●
In a minimized view (result icon) on the signal bar
●
In a diagram
The default position and the font size can be adjusted.
To arrange the result box on the display
1. Tap the "Minimize" icon in the floating result box.
The result box is closed, and a result icon with the result values is added to the
signal bar.
2. Drag the result icon from the signal bar to the diagram area and drop it on one of
the buttons. If you drop it somewhere else, a floating result box is created.
1
= Floating result box
2 = Table in a diagram on the left or right
3 = Table in a diagram above or below
4 = New tab
Displaying Results