Operating the Instrument
R&S
®
RTO
89Getting Started 1316.0833.02 ─ 10
5. To use a color that is not yet defined, tap "Userdefined Colors" and define the new
color settings. To see the effect of a setting change in the "Preview" area, enter the
value and press the ENTER key.
6. Tap "OK."
The signal bar is displayed in the new colors.
5.7 Accessing the Functionality
All functionality is provided in dialog boxes as known from computer programs. You
can control the instrument intuitively with the touchscreen. This section provides an
overview of the accessing methods and describes how to use the dialog boxes.
Each dialog box has four icons in the upper right corner:
Go back: opens the previously opened dialog box.
Go forward: opens the next dialog box.
Minimizes the dialog box to a small box that only contains the last selected function.
Closes the dialog box.
For direct access to important control and measurement functions use the toolbar, see
chapter 5.3, "Toolbar", on page 76.
To open a dialog box
► Perform one of the following actions:
● Tap the required menu, and then the menu entry.
● Press the function key on the front panel.
●
If a results box is open, tap the icon to open the corresponding dialog box.
● Touch and hold the signal icon to open the corresponding "Vertical" dialog box.
For XY-waveforms, the "XY Diagram" tab opens.
● Tap the horizontal or trigger label to open the "Horizontal" or "Trigger" dialog
box, respectively.
Accessing the Functionality
To Next Page
Loading...
