Preparing for Use
R&S
®
RTO
17Getting Started 1316.0833.02 ─ 10
If the operating system does not find a suitable driver, it prompts you to specify a direc-
tory that contains the driver software. If the driver software is on a CD, connect a USB
CD-ROM drive to the instrument before proceeding.
When a USB device is disconnected from the R&S RTO, Windows immediately detects
the change in hardware configuration and deactivates the corresponding driver.
The properties of external USB devices are configured in the operating system, not in
the R&S RTO software. It is recommended that you use mouse and keyboard to
access and modify the settings of the Windows operating system. To access Windows,
press the Windows key on the external keyboard, or select "File > Minimize" on the
R&S RTO menu.
Connecting a USB flash drive or CD-ROM drive
If installation of a USB flash driver or CD-ROM drive is successful, Windows informs
you that the device is ready to use. The device is made available as a new drive ("D:")
and is displayed under Windows Explorer. The name of the drive depends on the man-
ufacturer.
Connecting a keyboard
The keyboard is detected automatically when it is connected. The default input lan-
guage is English – US.
Use the Windows' "Start" menu > "Control Panel > Change keyboards or other input
methods" to configure the keyboard properties.
Connecting a mouse
The mouse is detected automatically when it is connected.
Use the Windows' "Start" menu > "Devices and Printers > Mouse" to configure the
mouse properties.
Connecting a printer
When printing a file, the instrument checks whether a printer is connected and turned
on and whether the appropriate printer driver is installed. If necessary, printer driver
installation is initiated using the Windows' "Add a Printer" wizard. A printer driver needs
to be installed only once.
You can load updated and improved driver versions or new drivers from an installation
disk, USB flash drive, or another external storage medium. If the instrument is integra-
ted in a network, you can also install driver data stored in a network directory.
Use the Windows' "Start" menu > "Devices and Printers > Add a printer" to install the
driver.
2.4.2 Connecting an External Monitor
You can connect an external monitor or projector to the DVI-D connector on the instru-
ment's rear panel. See also: "MONITOR (DVI-D)" on page 33.
Connecting External Devices
To Next Page
Loading...
