Trying Out the Instrument
R&S
®
RTO
43Getting Started 1316.0833.02 ─ 10
3. To move the waveform back to the center of the screen, eliminate the offset in the
vertical settings:
a) Press the CH1 key again.
b) Enter 0
V in the "Offset" field.
The waveform is now displayed in the center of the display, with the x-axis crossing
at 0 V but it might be unstable if the trigger level is above the waveform.
4. Tap the "Show signal bar" icon on the toolbar.
The signal bar disappears, and you can see the trigger level marker on the right.
Changing the Waveform Scaling and Position
To Next Page
Loading...
